Hangar 9 Clipped Wing Taylorcraft ARF Installation Manual

5, Hangar 9 Clipped Wing Taylorcraft ARF TAIL SECTIONS TAPED WHILE EPOXY CURES SULLIVAN TAIL WHEEL ASSEMBLY LANDING GEAR: With the fuselage upside-down, measure 3 5/8" back from the firewall and make a mark. This will indicate where the front of the landing gear will line up. Drill 4 holes through the landing gear and …

3, WING ASSEMBLY: The wing assembly begins with hinging the ailerons to each wing half. They come already in place with CA hinges inserted in the slots. I carefully removed the ailerons from each wing panel and placed a T pin through the center of each CA hinge. This would ensure that the same…

10, TAIL BRACES IN PLACE WING STRUTS ATTACHED TO THE WING. WING STRUT ATTACHED TO THE LANDING GEAR. THE WINDSHIELD IS TAPED IN POSITION WHILE THE GLUE DRIES. These will have to be installed and removed each time you bring the plane to the field. I would recommend having a hex driver and socket i…

13, was able to get a rather large diameter loop with no signs of the plane falling out at the top. Inverted flight required very little down elevator. I tried another loop, this time with the smoke system on. I was really happy with how much smoke the stock G23 muffler put out as I pain…

4, AILERON SERVO AND PUSHROD INSTALLATION SERVO LEAD AS IT EXITS THE WINGS CENTER SECTION The final step was to mount the wing to the fuselage. Before you can do this you must first attach the leading edge piece to the opening in front of the windshield former. The block is tapered so you must be su…

16, Search | Marketplace | Event Central | Local Clubs | Magazine | Product Ratings | New Products | Discussion Forums Photo Gallery | Instructor Search | Field|Track|Marina Search | RCU Youtube Channel | | RCU Twitter! Member Locator | Advertisers | Hobby Vendor Resource…