ACTi B94 Hardware Manual

28, www.acti.com Hardware Manual 28 2. Remove the plastic covering the dome cover. Final installation will look like the illustration below. Step 6: Connect to the Network Connect the other end of the network cable to a switch or injector. Then, connect …

19, www.acti.com Hardware Manual 19 Waterproof Solution with Naked Cable This section describes the procedures in using the bundled cable gland and an exterior-grade Ethernet cable. 1. Disassemble the cable gland as shown below: 2. Insert the cl…

35, www.acti.com Hardware Manual 35 Other Adjustments and Accessories How to Remove / Install the Camera Module How to Remove the Camera Module The camera module must be removed from the housing in the following situations: To install a memory card To connect …

25, www.acti.com Hardware Manual 25 b. Insert the sealing nut into the conduit gland body and then attach the clamping nut as tightly as possible to complete the cable solution. 8. If only the network cable will be connected, connect the network …

20, www.acti.com Hardware Manual 20 4. Attach the cable gland body to the hole of the camera. Attach to Camera Side Hole Attach to Camera Bottom Hole 5. If the cable will be routed along the surface, pull the network cable through the …

39, ACTi B94 www.acti.com Hardware Manual 39 8. There are 3 indents on the cover housing; note the indent (a) which is on the center of the extended curve of the cover. Place the bracket on the cover housing with the arrow on the bracket aligned to the indent (a). 9. Attach th…