Heatilator ADI-ZC-FB Installer's Manual

7, Heatilator • ADI-ZC-FB • 2032-900 Rev. E • 8/05 9 3 Installing the Insert Step 1. Installing the Vent System Vent System Installation Precautions Before starting installation of vent kits, the installer should read these instructions and the Vent Kit Instructions to ensure t…

11, Heatilator ADI-ZC-FB Heatilator • ADI-ZC-FB • 2032-900 Rev. E • 8/05 13 Step 2. Positioning, Leveling, and Securing the Insert • Place the insert into position. • Level the insert from side to side and from front to back. Use the leveling legs included with the manual bag if nece…

15, Heatilator • ADI-ZC-FB • 2032-900 Rev. E • 8/05 17 Step 9. Before Lighting the Appliance Before lighting the appliance, be sure to do the following: Remove all paperwork from the fireplace. Review safety warnings and cautions • Read the Safety and Warning Informatio…

12, Heatilator • ADI-ZC-FB • 2032-900 Rev. E • 8/05 14 Step 5. Gas Pressure Requirements Pressure requirements for these gas appliances are shown in the table below. Pressure Natural Gas Propane Minimum 5.0 inches 11.0 inches Inlet Pressure w.c. w.c. Maximum Inlet 14.0 inches 14.…

9, Heatilator • ADI-ZC-FB • 2032-900 Rev. E • 8/05 11 Figure 3. WARNING: THE EXHAUST VENT PIPE MUST ONLY BE CONNECTED TO THE EXHAUST STARTING COLLAR OF THE UNIT AND THE CENTER COLLAR OF THE TERMINATION CAP. A 3 FOOT SECTION OF STAINLESS STEEL FLEXIBLE LINER MUST BE ATTACHED DIREC…

20, Heatilator • ADI-ZC-FB • 2032-900 Rev. E • 8/05 22 Gas Appliance (Fireplace) Limited Lifetime Warranty HEARTH & HOME TECHNOLOGIES INC. (“HHT”) extends the following warranty for HEATILATOR ® gas appliances installed in the United States of America or Canada (the “Appliance…