Adel Trinity 788 Operation Manual

8, Notes: 1. The original password of the new lock (factory setting) is 111111 , and this original password will be cleared at the time of the successfully enrollment of the master fingerprint 2. The spare password must be of 6 digits, which is an arbitrary combination of the figur…

5, a) Press the on battery cover button, slide the battery cover upward and remove it, you can see one hole at each side, and inside each hole there is a button for setup; Specific operations: Trinity 788 Operation Manual Trinity 788 Operation Manual b) Remove either of the four batteries, pre…

4, Trinity 788 Operation Manual Trinity 788 Operation Manual Trinity 788 Door Lock Operation Instructions Buttons Function in setup state Other functions Button + Button - Button * Button # Enter the enrollment mode Enter the deletion mode Cancel current ope…

2, Notice 1. Keep your fingers clean when using this product. 2. In the state of new lock (factory setting), the lock can be unlocked with any fingerprint. 3. When opening the door, if the lock beeps an alarm and the indicator light flashes red, it's indicating the lock is i…

11, Adel Trinity 788 Trinity 788 Operation Manual Trinity 788 Operation Manual IX. Use of external power If it fails to operate the lock normally due to insufficient voltage, use a 9V battery for emergency power supply (pay attention to the positive and negative poles of the battery), and then place an…

7, Notes: 1. If the buzzer makes two short beeps, and the red indicator light flashes, the member fingerprint setup fails; 2. After successful enrollment of a member fingerprint, continue operation while the LED displays 0- to enroll other fingerprints needed; or else the LED will stop di…