Hensel Integra Mini 300 Operation & User’s Manual

22, Hensel Integra Mini 300 User manual Integra Mini 300 20 HENSEL-VISIT International GmbH This is how you replace a fuse: Â Open the fuse drawer 16 with the help of a small screwdri- ver and pull it out. 16 b a Note: The drawer can only be pulled out approximately 1 cm. The drawer contains two fuses. The rear fuse a…

14, User manual Integra Mini 300 12 HENSEL-VISIT International GmbH Â Tilt the protective glass cover slightly until it releases from the first and then the second spring. Â Remove the protective glass cover by gently pulling it straight out of the last spring. Note: Protective glass cover…

16, User manual Integra Mini 300 14 HENSEL-VISIT International GmbH Fuse protection, device The inside of the unit contains a built-in fuse. When this fuse responds, the unit is damaged. ATTENTION! Only authorized dealers may replace this fuse, see „10 Custo- mer service points“ on page 25. …

6, User manual Integra Mini 300 4 HENSEL-VISIT International GmbH Replacing the fuses ...................................................19 Replacement of flash tube .........................................20 Replacement of modeling light ..................................22 Error messages…

15, User manual Integra Mini 300 13HENSEL-VISIT International GmbH Set-up ATTENTION! Please regard the general safety instructions reference set-up location and surrounding area in the chapter „Set-up and initial use“ on page 5. Compact flash units can be used regardless of tilting angle. …

4, User manual Integra Mini 300 2 HENSEL-VISIT International GmbH 1 Preface Dear Photographer, By purchasing a Hensel-Visit compact flash unit Integra Mini 300, you have purchased a high-quality and high-performance product. We want you to use this product successfully for years to come and the…