iPECS eMG80 Installation Manual

56, iPECS eMG80 Hardware Description and Installation Manual Issue 1.0 49 4.7.7 BRIU2 (2 BRI -4 Channels- Interface Board) The BRIU2 board has two (2) BRI (2B+D) interface ports. The board, as shown in Description Figure 4.7.7-1, can be installed only on the CN2 connector of either an MBU…

107, iPECS eMG80 Hardware Description and Installation Manual Issue 1.0 100 9.3 Troubleshooting Table 9.3-1 eMG80 Troubleshooting Chart Problem Cause/Symptom Solution System power failure Power short circuit in some board(s) Exchange the malfunctioning board for one in g…

42, iPECS eMG80 Hardware Description and Installation Manual Issue 1.0 35 Figure 4.5.4-1 MBUID The following are included on the MBUID:  8 DKT interface circuits  4 SLT interface circuits  PRIU or BRIU2 interface connector  1 External Relay co…

17, iPECS eMG80 iPECS eMG80 Hardware Description and Installation Manual Issue 1.0 10 2.5.2 System Capacity Three System Capacity charts are provided below. These include the General System Maximum Capacities Table 2.5.2-1, the capacity based on the MBU type Table 2.5.2-2 to Table 2.5.2-5. Note that …

3, iPECS eMG80 Hardware Description and Installation Manual Issue 1.0 The use of this device in a system operating either partially or completely outdoors may require the user to obtain a license for the system according to the Canadian regulations. For further information contac…

54, iPECS eMG80 Hardware Description and Installation Manual Issue 1.0 47 Table 4.7.5-3 BH208 BRI Termination SW200 Pole Function Termination Remarks 1 & 2 Termination Resistor Port 1 Termination Resistor ON = Terminate OFF = Open Default = ON 3 & 4 Termination Resi…