Brunswick led pin light Installation & Operation Manual

12, LED Pin Lighting 12 2. Insert the stud of Left Hand Bracket (47-086148-009) into the hole left by hardware removal in previous step and secure it with M8 nut (11-051744-001). Refer to Figure 2. Figure 2 3. Remove the Right Hand side M8 screw and nut securing the wire way to the pinset…

23, 23 LED Pin Lighting To operate the controller, use the + and – buttons to switch programs. When a program is active, it will con- tinue to run until the controller box is unplugged or a different program is selected. By default, the controller will operate program 01 when it is turned on. …

9, Brunswick led pin light 9 LED Pin Lighting Pre-Installation LED Pin Light, 47-863001-000 Volts Hertz AC/DC Phase Amps Per Unit Watts Branch Circuit Customer's Responsibility 100-130 50/60 AC 1 0.5 60 2 wires + ground No more than 12 lights daisy chained in series 200-240 50/60 AC 1 .25 6…

13, 13 LED Pin Lighting 4. Insert the stud of Right Hand Bracket (47-086149-009) into the hole left by hardware removal in previous step and secure it with M8 nut (11-051744-001). Refer to Figure 3. Figure 3 …

21, 21 LED Pin Lighting 3. Using a 10ft/3m cable, connect the rst light to the second light, the second light to the third light, etc., until all the lights are chained together. Refer to Figure 11 . Figure 11 NOTE: If there is a large gap between two lanes, the data ca…

25, 25 LED Pin Lighting Since the address of the lights impacts the light pattern sequence and the perceived movement of the light from lane to lane, the actual address assignment is dependent on what affect the bowling center desires. It is suggested that the lanes be divided int…