Pacific energy Gmir.Bodya Installation And Operating Instructions Manual

19, 19 INSTALLER INFORMATION Figure 16: Gas and Electrical Connections Plumbing and Electrical Gas connection To make the required electrical and gas connections, start by positioning the gas fireplace. Connect the gas supply line to the 1/2” flare fi…

27, Pacific energy Gmir.Bodya 27 INSTALLER INFORMATION Figure 36: Front Cladding Securement Figure 37: Side Cladding Stand Figure 38: Side Cladding Figure 39: Side Cladding Securement …

12, 12 OWNER’S INFORMATION Section 2 Turn off gas and electrical power supply (if applicable) and allow ample time for unit to cool before servicing appliance. It is recommended that the fireplace and its venting should be inspected at least once a year by a qualified se…

9, 9 OWNER’S INFORMATION Section 2 Remote Flame Control The Proflame has six (6) flame levels. With the system on, and the flame level at the maximum in the appliance, pressing the down arrow key once will reduce the flame height by one step until the flame is …

29, 29 INSTALLER INFORMATION NOTE: Mixing venting components from different manufacturers is inadvisable. Figure 40: 4”x6-5/8" Rigid Piping Cross Reference Chart Figure 41: 4”x6-5/8" Rigid Pipe Components Cross Reference Chart Venting Components …

26, 26 INSTALLER INFORMATION Installation 1. Slide back the top cladding piece into the top of the fireplace as seen in Figure 32. Fasten using screws on front of fireplace as shown in Figure 33. 2. Place metal grill onto lower front cladding as seen in Figure 34.…