Packard Bell dot Disassembly Manual

12, 11 2. Remove the two rubber footpads. Fig. 15 Removing the foot pads. 3. Remove the screws that became accessible after removing the footpads (see Fig 15 ). 4. Turn the notebook over so the top is facing up. 5. Disconnect the LCD cable from the main board. Fig. 1…

16, Packard Bell dot 15 4. Remove the bezel from the LCD assembly. Fig. 23 Removing the LCD bezel. Webcam To remove the webcam, first remove the LCD bezel (see LCD Bezel on page 13), and then do the following: 1. Disconnect the cable from the header on the webcam module. Fig. 24 Location of the …

7, 6 4. Before removing the keyboard entirely, carefully release the white clip securing the flat cable and disconnect the cable from the header on the main board. Fig. 5 Releasing the keyboard flat cable. 5. Remove the keyboard entirely. Top and Base Cover To remove the top and bas…

17, 16 2. Extract the webcam module. Fig. 25 Removing the webcam module. Microphone To remove the microphone, first remove the LCD bezel (see LCD Bezel on page 13), and then do the following: 1. Disconnect the cable from the header on the microphone module. Fig. 26 L…

9, 8 7. Insert the small flat screwdriver into the two notches in the battery compartment to release the LED panel. Fig. 9 Location of the LED panel notches. 8. Turn the notebook over so the top is facing up. 9. Pry loose the LED panel. 10. Remove the two screws underneath the LED …

21, 20 4. Remove the four screws securing the LCD panel brackets (two on the left side and two on the right side). Fig. 33 Location of the LCD panel bracket screws. Note: In Fig. 33 only two screws are visible; the other two are located on the other side of the LCD panel.…