Olivetti d-COPIA3003MF Operation Manual

394, 11 11-27 Management 6 Press the U or V key to select [Default Setting]. 7 Press the OK key. The Default Setting menu appears. 8 Press the U or V key to select [Apply Limit]. 9 Press the OK key. Apply Limit appears. 10 Press the U or V key to select [Immediately], [Subsequently] or [Alert Only]…

273, 8-80 Default Setting (System Menu) Duplex Select binding orientation for duplex mode. The table below shows the available settings. Use the procedure below to select a duplex setting. 1 In the Sys. Menu/Count. menu, press the U or V key to select [Printer]. 2 Press the OK key. The Printer m…

144, 5 5-7 Sending Functions Original Orientation To send the document in the orientation that can be read properly, specify the upper orientation of original. To use the functions below, select the orientation in which the original is set on the platen. • 1-sided / 2-sided Selection When pla…

39, Preparation before Use 2-4 Preparing Necessary Cables The following interfaces are available to connect the equipment to a PC. Prepare the necessary cables according to the interface you use. Available Standard Interfaces Function Interface Necessary Cable Printer/Scanner /Network FAX* * Net…

321, 8-128 Default Setting (System Menu) 6 Press the OK key. NetWare appears. 7 Press the U or V key to select [On] or [Off]. If you select [On] and press the OK key, Frame Type appears. Press the U or V key to select the desired frame type. The available frame types are as follows: Auto 802.3 Et…

138, Olivetti d-COPIA3003MF 5-1 5 Sending Functions This chapter explains the functions available for sending originals. • Original Size................................................................. 5-2 • Sending Size ................................................................ 5-3 • Zoom ..........…