T&C TC30 Installation Instructions Manual

5, 5 TC30.NG06C 200411-16 Ember Material Placement LOG GRATE GLOWING EMBERS Ember Material A large bag of ember material is shipped with the  replace and needs to be installed on the burner to ensure optimum performance and ame appearance. 1. Pull apart the material into embe…

10, HOLE Fig #20 Fig #21 Minimum rate screw 5. With a ½” wrench remove the natural gas ori ce (#32) and replace with propane ori ce (#48)(our part # 5021.3407) (Fig. #17) 6. Fully open the primary air shutter. 7. Reinstall the manifold and air de ector 8. With a…

9, MAIN BURNER (#48) ORIFICE (5021.3407) MINIMUM RATE SCREW (5005.011) CONVERSION LABEL (5052.52085) For use with model: Pour utilise avec du modèle: LP GAS/ DU GAZ LP 12.5 in/wc /12.5 po/c.e. (3.11 kPa) 13.9 in/wc / 13.9 po/c.e. (3.45 kPa) 11.0 in/wc / 11.0 po/c.e. …

3, BULKHEAD PLATE 2 SCREWS 4. Secure the electrical bulkhead plate and gasket to the  rebox. (2 screws) Attach the ignition and sensor wires to the module. Red end to the connector marked by the red dot, white end to the connector marked by the white dot Fig.#2 & Fig.#3 Fig. # 2 Burner/…

2, T&C TC30 BURNER ASSEMBLY EMBER MATERIAL 7 PCS LOG SET HARDWARE PACKAGE LOG GRATE 2 TC30.NG06C 200411-16 Contents of Package Burner Installation 1. Place the keyhole slots in the burner over the two screws located in the  rebox base. (Fig. #1 & 1a) 2. Slide the burner back to engage t…