MBM SPRINT 3000 Operation Manual

15, MBM SPRINT 3000 oper3500.doc Page 14 23/01/2004 6. CORNER AND EDGE STAPLING The two paper stops are to aid edge stapling along the long side of 8½“ x 11 paper. Refer to figure 10. 1. Open the top perspex cover. Move the paper width guides to the posit…

14, oper3500.doc Page 13 23/01/2004 4. When paper is placed in the machine it breaks the light beam between the photocell emitter (part no. 2.83) and the photocell receiver (part no. 2.71). On the interruption of the beam the time set by the timer expires a…

8, oper3500.doc Page 7 23/01/2004 4. When the staple out system is in use, the staple count reset button should be pressed each time the stapling heads are reloaded. 4.2 Staple Out System (option): Each staple cassette should be c…

10, oper3500.doc Page 9 23/01/2004 4.5 Stapling / Folding Positions : 1. The Stapling and the Folding positions are adjusted as one. Loosen fold stop lock thumbscrew, figure 5. 2. Turn the fold stop adjustment wheel until the staple …

12, oper3500.doc Page 11 23/01/2004 4.6 Changing stapling head positions. 1. To move the stapling heads to the alternative positions, loosen the stapling head locking levers, figure 7, several turns and then slide the entire stapling unit to the new po…

17, oper3500.doc Page 16 23/01/2004 10. PROBLEM SOLVING. PROBLEM POSSIBLE CAUSES REMEDY Motor will not start Blown Fuse Switch off and unplug machine. Check and replace fuses as necessary Machine will not start when paper is insert…