Robinair 17800B Operating Manual

25, Model 17800B/17801B Recovery/Recycling/Recharging Unit 23 ENGLISH CHANGING THE VACUUM PUMP OIL When the vacuum pump has run for a total of 10 hours, the “OIL” message will flash on the display to signal that an oil change is needed. To change the vacuum pump oil, follow these st…

23, Robinair 17800B Model 17800B/17801B Recovery/Recycling/Recharging Unit 21 ENGLISH EVACUATION OVERVIEW 1. Verify the high- and low-side hoses are connected to the A/C-R system, and that the high- and low-side valves are open. 2. Press SHIFT/RESET to toggle the display to show “PROGRAM VACUUM MINUTES 15.00.”…

49, Model 17800B/17801B Recovery/Recycling/Recharging Unit 47 ENGLISH Robinair Limited Warranty Statement Rev . November 1, 2005 This product is warranted to be free from defects in workmanship, materials, and components for a period of one year from date of purchase. All parts and labor requir…

45, Model 17800B/17801B Recovery/Recycling/Recharging Unit 43 ENGLISH RECOVERY OPERATION Compressor does not start Problem: Main power switch is off. Solution: Turn on switch. Problem: Power cord is not plugged in, or there is no power at plug. Solution: Check circuit for power. Problem: “FULL�…

26, © 2001 Robinair, SPX Corporation 24 ENGLISH CHANGING THE FILTER-DRIER Change the filter-drier whenever refrigerant has been recovered from a burn-out system or when the display shows the “CH-F” message (which means that the unit has recovered 200 pounds of refrigerant since the last change)…

5, Model 17800B / 17801B Recovery/Recycling/Recharging Unit 3 ENGLISH GENERAL OPERATING GUIDELINES • The voltage at the unit must be ±10% of the unit’s rated voltage. Extension cords must be a minimum of 14 AWG and kept as short as possible. • To interrupt any procedure (other than clearing), …