Rointe RD SERIES Installation Manual

7, 07 vessel MUST be fitted to the safety group. The expansion vessel MUST be positioned with the entry point at the bottom – see Figure 2. IMPORTANT: Regular checks must be carried out to ensure that the expansion vessel is correctly pressurised to 0.15 or 0.3 MPa at all tim…

8, 08 4.9. Discharge arrangement. The tundish must be installed in a position so that it is clearly visible by the user. In addition, the discharge pipe from the Tundish should terminate in a safe place where there is no risk to persons in the vicinity of the discharge, be of metal and: (a) Be a…

15, 15 9.9 Programme When the indicator is on indicates that the Rointe RD Series water heater has been programmed using the M Series Remote Control. Please refer to its manual for further reference about how to programme the Rointe Digital System. 9.10 Anti legionnaire’s disease Our RD…

14, Rointe RD SERIES 14 9.6 Working the RD series Water Heater The RD series water heater is set in the factory to Stand by. Due to this, for the heater to work once installed press the ON button . 9.7 On and Stand-by When you press a beep will sound and the indicators will toggle between on and stand-by. In stan…

6, 06 The distance between holes for the wall mounting depends on the model, see the following table for reference: Model RDI050 RDI075 RDI100 RDI150 RDI200 Horizontal width between holes 350 mm 350 mm 350 mm 350 mm 350 mm Height between upper and lower holes 340 mm 573 mm 768 mm 490 …

9, 09 such discharges. SIZING OF COPPER DISCHARGE PIPE “D2” FOR COMMON TEMPERATURE RELIEF VALVE OUTLET SIZES            �…