Wyse X90 Installation Manual

17, 11 Figures 1 Flash module types 2 2 RAM module types 2 3 Upgrade Serial Label 3 4 Recommended tools 3 5 Removing bottom screws from access cover 4 6 Lifting off the access cover 4 7 Removing an older-type flash module 5 8 Removing screws from newer-type flash module 5 9 Removing the RA…

13, 7 Verifying the Mobile Thin Client’s Operation To verify that the mobile thin client works properly: 1. Reconnect the power cord and power adapter, and then press the power button on the mobile thin client to apply power. 2. After the mobile thin client restarts, close three windows that …

9, Wyse X90 3 Figure 3 Upgrade Serial Label Required Tools and Materials You will need the following recommended tools to install the kit: • Small Phillips screwdriver • Plastic alignment tools or equivalent Figure 4 Recommended tools Warning Flash and RAM modules may be susceptible to damage by Ele…

2, ii Copyright Notice © 2010, Wyse Technology Inc. All rights reserved. This manual and the software and firmware described in it are copyrighted. You may not reproduce, transmit, transcribe, store in a retrieval system, or translate into any language or computer language, in any …

3, iii Regulatory Compliance for Wyse Products Basic EMC and Safety Requirements Wyse appliances are compliant with the regulatory requirements in the regions listed below. U.S.A. - FCC Part 15 (class B) Canada - CAN/CSA-C22 No. 60950 Europe - EN 55022 (class B), EN 61000-3-2 (cla…

15, 9 Figure 13 Client Information 5. Verify that the MAC address and Serial Number matches the serial number and MAC address on the thin client. 6. V erify that the RAM Configuration is approximately 1984 MB. 7. V erify that the Flash Configuration is less than 1024 MB for a 1-GB flash upgrad…