SignWarehouse.com Enduracut Operation & User’s Manual

16, Step 1 Move the carriage to a new position. Step 2 Press the ORIGIN SET button to reset origin. 3.1.3 Cut Test Step 1 After sizing, press the ON/OFF LINE button to set as off-line mode. Step 2 Move the carriage to a preferred position. Step 3 Press CUT TEST butt…

13, Step 4 Push the lever backward to lower down the pinch rollers (Figure 2-21). Step 5 After turn on the power, the tool carriage will measure the size of the media automatically. And the plotting cutter begins to work. (X)Incorrect 2.3.2 Loading the Roll Media You can us…

2, NOTICE SignWarehouse.com reserves the right to modify the information contained in this user manual at any time without prior notice; un-authorized modification, copying distribution or display is prohibited. All comments, queries or suggestions conc…

19, 4.3 Cleaning the Pinch Rollers If the pinch rollers need a thorough cleaning, use a lint-free cloth or cotton swab to wipe away the accumulated dust from the rubber portion of the pinch rollers. To prevent the pinch rollers from rotating while cleaning, use your fingers to hold the p…

4, SignWarehouse.com Enduracut Important Information 1. General Information 1.1 Package Items 1-1 1.2 Product Features 1-1 1.3 The Appearance 1-2 2. Installation 2.1 Precaution 2-1 2.2 Blade Installation 2 2.3 Media Loading 2 2.4 Cable Connections 2 3. Operation 3.1 The Control Panel 3-…

8, 2. Installation 2.1 Precaution Please read below information carefully before you start installation. Notice 1 ¾ Make sure the power switch is off before installing the cutting plotter. ¾ Carefully handle the cutter to prevent any injuries. Notice 2 Choosing a proper place b…