ATH KN-10 Assembly Instructions Manual

10, G as-Fired Direct Vent Cast Iron Boilers – Field Assembl y Instruction s 10 Step 18 Remove the runner beams and bolt block to base The block assembly is extremely heavy. Use care as the beams are removed to ensure the block does not slide during the process. 1. When the sectio…

22, G as-Fired Direct Vent C ast Iron Boilers – Field Assembl y Instruction s 22 Figure 1 Plastic tube routing …

24, IN UNITED STATES: 260 NORTH ELM ST. • WESTFIELD, MA 01085 • (413) 564-5515 • FAX (413) 568-9613 IN CANADA: 7555 TRANMERE DRIVE • MISSISSAUGA, ONT. L5S 1L4 • (905) 670-5888 • FAX (905) 670-5782 www.knseries.com …

13, 13 G as-Fired Direct Vent Cast Iron Boilers – Field Assembl y Instruction s Step 26 Install burner inspection ports (front and rear) 1. Each burner inspection port consists of a plate, gasket, inspection glass, and another gasket. 2. Place against the mounting boss …

6, G as-Fired Direct Vent Cast Iron Boilers – Field Assembl y Instruction s 6 Step 7 Place ceramic ber ba e in  ueway Use of an approved dust respirator is strongly recommended when handling the insulating components of the boiler. Do not use ue ba es if they have …

7, ATH KN-10 7 G as-Fired Direct Vent C ast Iron Boilers – Field Assembl y Instruction s Step 10 Apply RTV to machined surfaces Rubber gloves are recommended for this procedure. 1. Apply a bead of silicone RTV (supplied with boiler) on the perimeter surfaces of the section and arou…