AirStage ABYA12GATH Installation Manual

6, En-5 1 4.2. Pipe requirement CAUTION Refer to the Installation Manual of the outdoor unit for description of the length of connecting pipe or for difference of its elevation. • Use pipe with water-resistant heat insulation. CAUTION Install heat insulation around both the gas and li…

16, AirStage ABYA12GATH En-15 9. TEST RUN ] 1 9.1. Test run using Outdoor unit (PCB) • Refer to the Installation Manual for the outdoor unit if the PCB for the outdoor unit is to be used for the test run. ] 1 9.2. Test run using remote controller • Refer to the Installation Manual for the remote controller to pe…

5, En-4 B-4. Installing indoor unit Reset the hex bolts as shown in the fi gure Unit : mm Indoor unit Hex bolt 8 to 13 Apply the indoor unit to the brackets. Indoor unit Bolt Bracket Now, securely tighten the hex bolts in both sides. 3.3.3. Barrier and RFM base removal and installation…

12, En-11 Controller PCB Cable tie (Field supply) Clamp Cable tie (Field supply) (Clamp with other cables) 7. FIELD SETTING There are 3 methods for address setting by FIELD SETTING as follows. Set by either of the methods. Each setting method is described (1) to (3) below. (1) IU AD, REF AD SW settin…

10, En-9 CAUTION To peel the fi lm from the lead cable, use a dedicated tool that will not damage the conductor cable. When installing a screw on the terminal block, do not cut the cable by overtightening the screw. On the other hand, an undertightened screw can cause faulty contact, which…

4, En-3 CAUTION Install the indoor unit, power supply cable, transmission cable, and remote controller cable at least 1 m away from a television or radio receivers. The purpose of this is to prevent TV reception interference or radio noise. (Even if they are installed more than 1 m apart, you coul…