Allied Telesis CentreCOM AT-200 Series Operation & User’s Manual

18, AT-200 Single Port Transceiver 11 CentreCOM AT-200 Manual Feedback Form Please tell us what additional information you would like to see discussed in the manual. If there are topics you would like information on that were not covered in the manual, please photocopy this page, answer …

6, v ENERGIA RADIADA Este producto comercial ha sido probado y cumple con las normas requeridas en los EE. UU. para un dispositivo de Clase A. Este producto ha sido probado y cumple con los requisitos Vfg 243/1991 de Alemania para un dispositivo de Clase B. SEGURIDAD La segu…

13, 6 The SQE/Heartbeat is factory set to the “0” (disabled) position. Unless your application calls for the heartbeat signal to be enabled, leave this switch in the “0” position. (See “Heartbeat configuration” on page 1.) Figure 4: AT-200 with N-Series Thicknet Backb…

16, AT-200 Single Port Transceiver 9 ❑ AUI cables may have a maximum 257 ns propagation delay, as used for computing the worst case propagation delay of a cable system  AUI cable propagation delay is approximately 5.13 ns/meter ❑ AUI cable internally consists of four shielded t…

19, CentreCOM is a trademark of Allied Telesyn International Corp. Copyright 1994 Allied Telesyn International Corp. All rights reserved. No part of this publication may be reproduced without prior written permission from Allied Telesyn International Corp. Allied Telesyn International…

11, Allied Telesis CentreCOM AT-200 Series 4 4. Place the cable in the cable channel of the tap body. Figure 2: Assembling the Coaxial Active Tap 5. Slide the clamp assembly onto the tap body until it stops. 6. Using the hex wrench, thread the button socket screw into the clamp frame until the pressure block bottoms on the c…