Qlogic QConvergeConsole CLI 8100 Series Operation & User’s Manual

285, Qlogic QConvergeConsole CLI 8100 Series 8–Configuring FCoE in a Linux Environment Boot-from-SAN FE0254601-00 A 8-31  Set the boot order in the system BIOS configuration menu: first, the optical drive, then the disk, and then the SAN-boot device. Placing the optical drive at the top of the boot order enables the ser…

135, FE0254601-00 A 5-1 5 Installation in a VMware Environment Overview This section describes how to install a QLogic 8100 Series Adapter in VMware ® ESX/ESXi environments including, hardware installation, driver installation, and software installation. Installing Hardware To install the adapt…

65, 3–Installation in a Windows Environment Installing Software FE0254601-00 A 3-15 Adapter. For information about identifying QLogic devices in the Other Devices section, refer to “Identifying Unnamed Devices” on page 3-8. Figure 3-13. QLogic 8100 Series Adapter Device Entries b. To install the …

93, 3–Installation in a Windows Environment Installing Management Tools FE0254601-00 A 3-43 The Install Complete dialog box (Figure 3-56) opens. Figure 3-56. Install the QConvergeConsole: Install Complete Notification 6. Click Done to exit the installer. You have installed the QConverg…

188, 6–Configuring NIC Functionality in the Converged Network Adapter Configuring the NIC in a Windows Environment 6-20 FE0254601-00 A 11. Configure of the team by assigning a dynamic or static IP address to the QLogic VT-IM Miniport Driver logical interface. The windows command, ipconfig /all, l…

90, 3–Installation in a Windows Environment Installing Management Tools 3-40 FE0254601-00 A Installing and Launching the QConvergeConsole The QConvergeConsole Installer for Windows is a self-extracting utility that installs the QConvergeConsole and related files. After you install the applica…