DURKOPP ADLER 580 - Operating Instructions Manual

12, 2.3 Thread take-up disc Caution: Danger of injury! Turnthemainswitchoff. Adjust the thread take-up disc only with the machine switched off. Standard checking When the arm shaft has been locked with the locking pin 2 in such a way that the looper turret is in its left end position (left sti…

120, Error description Possible cause Remedy Faulty rotation of the sew ing works Possible rough running of individual components Check all components belonging to the sewing works rotation. If neither faulty components nor rough running are found, the problem can in some cases be solved by altering…

31, 8.6 Locking of the clamping plates Caution: Danger of injury! Exercise utmost caution when making adjustments with the machine running. Standard checking There must be a minimum clearance in the height of the inserted clamping plates 2 when: · no material is loaded. · approx. 8 mm thick materia…

87, DURKOPP ADLER 580 - 29. Service menu (technician level) In the service menu of the 580 various basic adjustments and test programs can be executed. 29.1 Activating the service menu – Press key “F” at the control panel. A code query appears. – Enter the code “2548” with the cursor keys. – Press key “OK…

57, 18. Throat plate Caution: Danger of injury ! Turnthemainswitchoff. Adjust the throat plate only with the machine switched off. Standard checking The needle should penetrate the needle hole of the throat plate on one side at the edge 1. The throat plate has to be positioned as high as possible. Thus …

48, 10.7 Cutting pressure Standard checking In order to keep the strain of all components as low as possible and to increase the life of the cutting knife, the cutting pressure can be adjusted. Depending on the sewing material and the material thickness, the cutting pressure should be adjusted to be …