Seagull Models SPORT CRUISER Assembly Manual

25, 25 www.seagullmodels.com BALANCING.  1) It is critical that your airplane be balanced correctly. Improper balance will cause your plane to lose control and crash. THE CENTER OF GRAVITY IS LOCATED 110 MM BACK FROM THE LEADING EDGE OF THE WING AT THE WING ROOT.  3) Turn the airp…

17, 17 www.seagullmodels.com INSTALLING THE SPINNER. Install the spinner backplate, propeller and spinner cone. The propeller should not touch any part of the spinner cone. If it does, use a sharp modeling knife and carefully trim away the spinner cone where the propeller comes in contact with it. …

14, SPORT CRUISER. Instruction Manual. 14 Trim and cut. COWLING. Trim and cut.  1)Slide the fiberglass cowl over the engine and line up the back edge of the cowl with the marks you made on the fuselage then trim and cut as shown. m2. 9 Screw. 2)Install landing gear at the top Fuselage. Trim and cut. …

12, Seagull Models SPORT CRUISER SPORT CRUISER. Instruction Manual. 12 LANDING GEAR INSTALLATION: A. NOSE GEAR: 1 2 3 4 5 8 6 7 3 5) Slide the pushrod tube in the firewall and guide it through the fuel tank mount. Use medium C/A to glue the tube to the firewall and the fuel tank mount. 6) Connect the Z-bend in the 600mm thrott…

6, SPORT CRUISER. Instruction Manual. 6 3mm. Epoxy Aileron control horn. HINGING THE ELEVATOR. Glue the rudder hinges in place using the same techniques used to hinge the ailerons. HINGING THE RUDDER. Glue the rudder hinges in place using the same techniques used to hinge the ai…

16, SPORT CRUISER. Instruction Manual. 16 Balsa stick. Electric motor. Battery. 4) Locate the plywood battery tray to the fuselage. Tighten the screws using machine screws M3x15mm to secure the tray in position. Epoxy. M4x15mm. Epoxy. 150mm. 5.2mm. M3 x 15mm. Battery. 5) Attach the speed control to th…