EarthWalk eBuddy Series 3 Operation & User’s Manual

57, Chapter 3: Hardware installation eBuddy User Manual -48- 2/4/00 You should only attempt to charge the battery pack at ambient temperatures between 41°F (5°C) and 104°F (40°C). Figure 3-3. Removing the battery pack ebud.book Page 48 Friday, February 4, 2000 11:11 AM …

77, EarthWalk eBuddy Series 3 Chapter 5: BIOS setup eBuddy User Manual -68- 2/4/00 DRAM Read Burst (EDO/FP) This sets the timing for burst mode reads from two different DRAM (EDO/ FPM). Burst read and write requests are generated by the CPU in four separate parts. The first part provides the location within the D…

66, -57- 2/4/00 5: BIOS setup The eBuddy’s BIOS controls many of the computer’s functions. Some of these are referred to in other chapters of this manual. You can enter the BIOS setup program by pressing the Delete key when the system is booting up. The Delete key is in the low…

81, Chapter 5: BIOS setup eBuddy User Manual -72- 2/4/00 HDD Power Down This setting will determine how many minutes elapse from the last keyboard or mouse input until the HDD powers down. You can set the delay from 1 to 15 minutes, or disable HDD Power Down altogether. MODEM Use IRQ You can o…

65, Chapter 4: Software eBuddy User Manual -56- 2/4/00 System Software This section describes the additional software that accompanies your eBuddy. Insert the CD-ROM containing these applications to view instructions for load- ing them. The CD-ROM will run automatically, displaying a menu fo…

30, -21- 2/4/00 2: Peripherals and accessories This chapter describes the installation and setup of the following peripherals and accessories: ❑ Integrated wireless card ❑ IrDA infrared port ❑ USB port ❑ Modem ❑ Serial port ❑ Parallel port ❑ External monitor ❑ Externa…