GREAT PLANES Super Skybolt Instruction Manual

12, ❏ 3. Test fit the stabilizer in the fuselage. Center the stab left and right in the fuselage. Stand back 15 to 20 ft [5 to 6 m] and check to be sure the stab is parallel to the wing. Adjust the stab saddle as needed until the stab and wing are parallel. ❏ 4. Measure the distance from each …

21, ❏ 4. Install a strain relief on the receiver antenna and route it through the pre-installed antenna tube. Trim the covering from the end of the tube which is located on the right side of the fuselage just below the trailing edge of the horizontal stabilizer. ❏ 5. Install your receiver batte…

1, WARRANTY Great Planes ® Model Manufacturing Co. guarantees this kit to be free from defects in both material and workmanship at the date of purchase. This warranty does not cover any component parts damaged by use or modification. In no case shall Great Planes’ liability excee…

29, ❏ 14. Make sure the fuel lines are connected and are not kinked. ❏ 15. Balance your propeller (and spare propellers). ❏ 16. Tighten the propeller nut and spinner. ❏ 17. Place your name, address, AMA number and telephone number on or inside your model. ❏ 18. Cycle your receiver battery …

5, • When you see the term test fit in the instructions, it means that you should first position the part on the assembly without using any glue, then slightly modify or custom fit the part as necessary for the best fit. • Whenever the term glue is written you should rely upon your experience to…

13, GREAT PLANES Super Skybolt ❏ 8. Fit the vertical fin into the slot at the top trailing edge of the fuselage. As you did with the stabilizer, mark the location of the fuselage onto the fin. Remove the fin and trim away the covering 1/16" [1.6 mm] inside your lines. The covering on the trailing edge of the…