smartvue S9C1 Operation & User’s Manual

100, 100 SD card control ■ Enable cyclic storage: Check this item if you want to enable cyclic recording. When the maximum capacity is reached, the oldest le will be overwritten by the latest one. ■ Enable automatic disk cleanup: Check this item and enter the number of days you wis…

97, 97 If successful, you will receive a test.txt le on the network storage server. 3. Enter a server name. 4. Click Save to complete the settings and click Close to exit the page. Recording Settings Click Add to open the recording setting page. In this page, you …

110, 110 Specications Power supply 12V DC ± 10 % Consumption current 12V DC / 0�9 A Image pickup device 1/3�2 inch (4:3), CMOS Digital Image Sensor Full resolution Horizontal 1600, vertical 1200 pixels Scanning system Progressive Minimum object illuminance 2�0 lux / F1�8 (Max gain 4x, Ex…

69, 69 Sensor Settings Advanced Mode Click Sensor Settings to open the Image Sensor Settings page. On this page, you can set the maximum exposure time, exposure level, and AGC (Auto Gain Control) settings. You can congure two sets of sensor settings: one for normal situations, the ot…

21, smartvue S9C1 21 Set up the Network Camera through Power over Ethernet (PoE) (S9C2 only) When using a PoE-enabled switch The Network Camera is PoE-compliant, which allows it to be powered via a single Ethernet cable. If your switch/router supports PoE, refer to the following illustration to …

55, 55 Note that as JPEG only transmits a series of JPEG images to the client, to enable the two-way audio function, make sure the video mode is set to “MPEG-4” on the Audio and Video Settings page and the media option is set to “Video and Audio” on the Client Settings page. Please refer…