I-Sotec i-soamp-2 Manual 

10, – 10 – Loudspeaker wiring diagram front loudspeakers: The i-soamp-2, which drives the front loud- speakers, is connected as described in Chapter 1.3. Instead of the ISO loudspeaker receptacle of the car radio, however, now the free ISO loudspeaker receptacle of the split-adaptor A…

7, I-Sotec i-soamp-2 – 7 – 1.3 „Normal“ loudspeaker connection option The i-soamp-2 is connected to the front speakers (e.g. for small convertibles). The selector switch is set at the „normal“ position. This means that all loudspeakers are operated without affecting the frequency response. „Nor…

6, – 6 – 1.2 Overview: the i-soamp-2 connection principle This depiction is designed to give you an overview of how the i-soamp is connected to your vehicle‘s components in principle. The following steps are required to connect the i-soamp-2 to your existing car radio: 1. Connect…

14, – 14 – cable is connected to the grounding point; make sure there is a good electrical contact. 3. The red cable is connected to the positive terminal of the battery via a suitable fuse. CAUTION: A main fuse must be inserted into the positive cable a maximum of 12“ (=30 cm) distance from …

9, – 9 – The i-soamp-2 has a max. current requirement of 15A per amplifi er. In a few vehicles and when connecting to two amplifi ers, the radio wiring cannot cover this power requirement. The i-soamp-2 must then be connected directly to the battery. (See 1.7) Loudspeaker Wiring Diagr…