FLO TV TV Accessories Installation Manual

22, - 22 - Audio & Video Output Cable To connect FLO TV to a Factory VES via the Factory A/V Input: The Audio/Video Output connectors on the Main Harness provide the audio and video output from the FLO TV Module, which must be connected to the vehicle’s factory VES. Refer to Figure 1, he…

4, - 4 - Safety Precautions Installation of the FLO TV product requires careful planning and preparation. Be extremely careful of the airbags in vehicles and not to have any FLO TV component or wire harness interfere with them. Keep wiring away from any air bag wiring (usually id…

14, - 14 - Figure 4 – FLO TV Antenna Placement 4” 4” 4” 4” …

9, FLO TV TV Accessories - 9 - FILTER BOX Wiring Diagrams An overview of the FLO TV kit wiring diagram for connection to a Factory Vehicle Entertainment System (VES) is shown in Figure 1 below. Figure 1 – FLO TV Wiring Diagram with Factory VES & A/V Input …

12, - 12 - FLO TV Module Installation Choose a mounting location for the FLO TV Module which is convenient, such as under a seat, under or behind the dashboard, or in the trunk, etc. The location should be one where the FLO TV Module will not get damaged or kicked and where the wi…

16, - 16 - 6. Clean the surface area of the vehicle where the FLO TV Antenna and antenna tail will be installed. Ensure that the vehicle surface is clean and clear of any dirt or debris. 7. Remove the plastic liner from the adhesive backing on the bottom of the FLO TV Antenna. Remove the two pl…