Jlinks H.264 Cube Operation & User’s Manual

56, Network Camera User’s Guide 56/94 E-Mail: Setup E-Mail configuration You may setup SMTP mail parameters for further operation of Event Schedule. That’s, if users want to send the alarm message out, it will need to configure parameters here and also add at least one event schedule to en…

2, Network Camera User’s Guide 2/94 Owner's Record The model and serial numbers are located at the bottom of device. Record these numbers in the spaces provided below. Refer to these numbers whenever you call upon your dealer regarding this product. Model No. ____________________ …

21, Jlinks H.264 Cube Network Camera User’s Guide 21/94 Install the Device behind a NAT Router Once installed, the device is accessible on your LAN. To access the device from the Internet you must configure your broadband router to allow incoming data traffic to the device. If the device is inst…

63, Network Camera User’s Guide 63/94 Name: User can specify multiple HTTP servers as wish. Therefore, user needs to specify a name for each HTTP server setting. URL: Type the server name or the IP address of the HTTP server. Test: Check the HTTP server whether it …

65, Network Camera User’s Guide 65/94 Event Schedule: Configure the event schedule Setting This menu is used to specify the schedule of Event or Schedule Trigger and activate the some actions provided by this device. Where the Schedule Trigger will be activated by user-define interval w…

69, Network Camera User’s Guide 69/94 Appendix A: Restore Factory Default Settings There is a button hidden in the pinhole near to the DC power connector. This button is used to restore the all factory default settings. Sometimes restarting the device will make the system back …