Hangar 9 P-40B Warhawk 50 ARF Assembly Manual

29, 29Hangar 9 P-40B Warhawk 50 ARF  3. Use low-tack tape to secure the engine mounting template for the Power 52 installation to the fuselage. Use the center hole in the firewall and template for alignment. Use a drill and 1/16-inch (1.5mm) drill bit to drill the pilot holes for t…

38, Hangar 9 P-40B Warhawk 50 ARF 38 Hangar 9 P-40B Warhawk 50 ARF  7. Repeat steps 4 though 6 to install the elevator control horn. The holes in the elevator control horn must align with the hinge line when positioning the horn.  8. Use a pin vise and 5/64 -inch (2mm) drill bit to enlarge the hole in the …

2, 2 Hangar 9 P-40B Warhawk 50 ARF WARNING: Read the ENTIRE instruction manual to become familiar with the features of the product before operating. Failure to operate the product correctly can result in damage to the product, personal property and cause serious injury. This is a sophisticate…

21, 21Hangar 9 P-40B Warhawk 50 ARF  24. Use a pin vise and 1/16-inch (1.5mm) drill bit to drill six holes (three on each side) to secure the cover to the wing. Space the holes evenly as shown. Prepare the holes by threading the screws into the holes, then hardening the holes using t…

12, 12 Hangar 9 P-40B Warhawk 50 ARF  3. Mark the wing joiner and wing panel using a felt-tipped pen. This is done so you can orient the joiner correctly in this section of the manual.  4. Slide the joiner into the wing panel and use a pencil to mark the joiner against the wing. R…

43, 43Hangar 9 P-40B Warhawk 50 ARF  8. Measure 9 7 / 16 inches (240mm) from the wing center. Use a 7/32-inch (5.5mm) brass tube to make the hole for the inboard machine gun. Note the position of the gun in reference to the leading edge in the photos and on the box.  9. The second machine gun…