Hemisphere GPS Vector V103 Operation & User’s Manual

3, This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Copyright Notice…

9, Vector V103 / V113 User Guide 3 PN 875-0287-000 Rev A1 Chapter 1: Introduction The V103/113’s GPS antennas are separated by 50.0 cm between their phase centers, resulting in better than 0.30° rms heading performance. The V103/113 provides heading and positioning updates of up to 20 …

10, Vector V103 / V113 User Guide 45 PN 875-0287-000 Rev A1 Appendix B: Technical Specifications Table B-3: Communication specifications Item Specification Serial ports 1 RS-232 (full-duplex) 2 RS-422 (1 full duplex, 1 half duplex) Baud rates 4800, 9600, 19200, 38400 Correction I/O protocol RTCM SC-10…

18, Vector V103 / V113 User Guide 37 PN 875-0287-000 Rev A1 Chapter 3: Operation 95 Satellite ephemeris data 96 Code and carrier phase 97 Processor statistics 98 Satellites and almanac 99 GPS diagnostics Table 3-5: Parameters specific to $JATT command Parameter Description Query Speci…

29, Hemisphere GPS Vector V103 Vector V103 / V113 User Guide 23 PN 875-0287-000 Rev A1 Chapter 2: Installation Powering the V103/113 Power Considerations For best performance use a clean and continuous power supply. The V103/113 power supply features reverse polarity protection but will not operate with reverse polarity. Se…

21, Vector V103 / V113 User Guide 15 PN 875-0287-000 Rev A1 Chapter 2: Installation Pole Mounting the V103/113 If you need the GPS-assisted roll measurement, install the V103/113 perpendicular to the vessel’s axis. If you do not need this measurement, install the V103/113 parallel wit…