Vantage Hearth CC-STAT Installation Manual

6, Vantage Hearth CC-STAT SECTION ONE - Installation CC-STAT ©Vantage, 41184 / IS-1308191-A page 4 of 23 Power & Reset Options The InFusion System retains settings in the event of a power outage. When power is restored, all settings, including Network Override aka Occupied/Unoccupied modes are restored. Th…

26, 1061 South 800 East • Orem, Utah 84097 • 800.555.9891 www.vantagecontrols.com 61000955 B2205806 © 2012 Legrand Home Systems Vantage is a tradema…

14, SECTION TWO - Setup & Testing CC-STAT ©Vantage, 41184 / IS-1308191-A page 12 of 23 SECTION TWO – SETUP & TESTING This thermostat has the option of being used in heat pump or heat/cool systems. Switch SW1 located on the back of the thermostat’s face to select the proper oper…

23, SECTION FIVE - Troubleshooting CC-STAT ©Vantage, 41184 / IS-1308191-A page 21 of 23 SECTION FIVE – TROUBLESHOOTING Display Is Blank Check circuit breaker and reset* if necessary. Make sure power switch at heating & cooling system is on. Make sure furnace do…

24, SECTION SIX - Error Codes CC-STAT ©Vantage, 41184 / IS-1308191-A page 22 of 23 SECTION SIX – ERROR CODES If the thermostat enters an error mode, all outputs are turned off. The thermostat attempts to recover every 10 minutes. If the error does not clear, use the reset* button. This wi…

21, SECTION THREE - Quick Reference To Controls & Display CC-STAT ©Vantage, 41184 / IS-1308191-A page 19 of 23 Humidistat The Model CC-STAT has the option of being configured as a humidistat* that can control a humidifier and dehumidifier. Note: The CC-STAT is set to operate as a humid…