Vectaire ELEGANCE EL1003DT Installation And Operating Instructions Manual

4, adjustable over-run timer (adjustable from 0 to 30 minutes) has completed its cycle. The boost speed can also be activated by as described for model EL1003DT EL1003HDTLV - SELV, 12v version of EL1003HDT 4 INSTALLATION 1 2 3 4 5 …

3, WARNING: Damage could be caused to the product if the installation instructions are not followed • The product should not be used in an ambient temperature higher than 40°C (104°F). • The product should not be exposed to atmos- pheric agents (rain, sun, snow, etc.). • The product or i…

6, Vectaire ELEGANCE EL1003DT 56 11 INSTALLATION 1. check there is nothing missing in box 2. remove front cover 3. drill hole in wall - allow extra width if using ducting - it is the installer's responsibility to use the appropriate core cutter to obtain the correct hole diameter. 4. use fan assembly as template to ma…

7, ELs - 3 Speed with Cord 7 WIRING DIAGRAMS JUMPER SWITCH These fans are designed to run continuously at one of 2 lower speeds fixed at installation using the jumper switch. EL1003, EL1003DT and EL1003HDT: Minimum Speed 1 - Jumper 2 in Minimum Speed 2 - Jumper 2 out To activate delay-on timer …

8, TRIMMER ADJUSTMENT To adjust the humidistat and timer trimmers, remove the front cover of the fan (Fig 2) to access the trimmers. The humidistat (HY) can be adjusted between 40% and 90% relative humidity. Turn clockwise to decrease sensitivity and set at a higher level of relative hu…