Venstar T4700 Owner's Manual And Installation Instructions

15, 10 Installation Instructions Wire Connections If the terminal designations on your old thermostat do not match those on the new thermostat, refer to the chart below or the wiring diagrams that follow. Wire from the Install on the old thermostat Function new thermostat …

22, 17 User Setup - Backlight Operation How to Change Settings in the Setup Screens To enter Advanced Setup, press the SETUP button, then press MODE. Use the WARMER or COOLER buttons to adjust the value of your selection. Press MODE to advance to the next setup step. Press SETUP again to leav…

13, Viewing the Temperature Sensors OUTDOOR TEMP - Press the OUTDOOR button to view the current outdoor temperature. If connected to a Skyport account, pressing outdoor button will show the temperatures for your location if you don’t have a wired sensor connected. Press the …

33, 28 Installer Setup Humidity and Dehumidity (setup steps 32 -37, 45-47) Humidity Only With Heat (Setup Step 32) - When this step is set to ON, Humidity will not run without a demand for Heat. Fan With Humidity Demand (Setup Step 33) - Specifies if the fan should be turned on with a d…

25, 20 User Setup Please follow the instructions included with the Wi-Fi module to connect to an Access Point or view status. The general instructions are below. Wi-Fi Module If the is present on the display then the thermosat is connected to the Wi-Fi Access Point. If just the …