Verine Fontana HE MK2 NPHL**RN2 Manual, Installation, Maintenance & User Instructions

33, c) With the product in “MANUAL” mode the fire can now be switched between HIGH rate heat input and LOW rate heat input by pressing the “DOWN” arrow on the handset. To reduce the flame height of the main burner incrementally, press the arrow momentarily. To reduce the heat in…

26, SECTION 4 MAINTENANCE Servicing Notes Servicing should be carried out annually by a competent person such as a GAS SAFE registered engineer. It is a condition of Verine Fires extended guarantee scheme that this is carried out by a competent person i.e a GAS SAFE registered Engineer in acc…

37, 5.5 CLEANING WARNING : Before attempting any cleaning operation ensure that the fire has been allowed to fully cool. 5.5.1 CLEANING THE TRIM AND PAINTED METAL PARTS The extruded aluminimum trim that is supplied for use with this product must be gently cleaned with a damp cloth only. Abrasive clea…

14, Verine Fontana HE MK2 NPHL**RN2 SECTION 3 INSTALLATION OF FIRE 3.1 FITTING THE FUEL-BED LOGSET a) Place the base log behind the burner gauze as shown below in figure 16 onto the raised platform. Fig. 16 b) Place the bark chippings over the burner as shown below in figure 17, do not allow the bark chippings to cover the a…

15, c) Fit Log “B” into position on the right hand side of the fuel-bed base log as shown below in figure 18, using the groove in the base log as a guide for placement. Fig. 18 d) Fit Log “C” into position on left hand side of the fuel-bed base log as shown below in figure 19, using …

20, 3.4 LIGHTING THE APPLIANCE I MPORTANT : IF THE BURNER IS EXTINGUISHED FOR ANY REASON YOU MUST ENSURE THAT YOU WAIT A FULL FIVE MINUTES BEFORE ATTEMPTING TO RE-LIGHT THE FIRE. The product is controlled by the remote handset supplied with the fire. Ensure the 9V battery as supplied in the loose ite…