GBC 930-400 Operation Manual

40, Maintenance and Troubleshooting Falcon 36 Operation Manual 4-6  GBC Pro-Tech 1997 October 5. Adjust the nip by turning the adjusting bolt using an ¾" open end wrench (clockwise to lower the roll end and counter clockwise to raise the roll end). Adjust the ends of the upper m…

32, GBC 930-400 Operation Falcon 36 Operation Manual  GBC Pro-Tech 1997 October 3-14 352&(66 &21752/ &+$57 D Two Pass Mount and Hot Overlaminate, First Pass MATERIALS Upper Media 3 mil Gloss Image Media Bond Paper Lower Media Pro-Mount Mounting Substrate N/A LAMINATOR SETTINGS Top H…

43, Falcon 36 Operation Manual Maintenance and Troubleshooting  GBC Pro-Tech 1997 October 4-9 2XWSXW 7URXEOHVKRRWLQJ *XLGH Problem: D waves in the image, not in the laminate. Hints: • Check paper tension. • Check relative moisture content of the paper. Problem: D waves in the laminate. Hints:…

38, Maintenance and Troubleshooting Falcon 36 Operation Manual 4-4  GBC Pro-Tech 1997 October &OHDQLQJ Tools required: • Adhesive coated board • 80% isopropyl alcohol (or dishwashing detergent) • Rubber cement eraser • Several 100% cotton terry cloths • Protective rubbe…

20, Operation Falcon 36 Operation Manual  GBC Pro-Tech 1997 October 3-2 2SHUDWRU &RQWUROV The operator controls for the Falcon 36 Laminator are located on the front and rear of the unit, to the right of the operator position. The names and functions of these controls are as fo…