Vermont Castings VFI33LNV Installation And Operating Instructions Manual

11, VFI33 Vent Free Gas Fireplace System 20307670 11 SECURE HEATER TO FLOOR NOTE: Clearance requirements as detailed in “Clearances and Height Requirements” section of this manual must be met before securing heater in place. To prevent movement, the heater must be secured to the fl oor or heart…

13, VFI33 Vent Free Gas Fireplace System 20307670 13 GAS PRESSURE — MILLIVOLT CHECKING GAS PRESSURE: MILLIVOLT CONTROL Figure 17 The valve regulator controls the burner pressure which should be checked at the pressure test point. Turn captured screw counter clockwise two or three …

10, VFI33 Vent Free Gas Fireplace System 10 20307670 CLEARANCES and INSTALLATION The gas log heater must be installed at least 5" above any combustible fl ooring material, such as carpeting or tile, which is closer than 14" to the base of the fi replace. Figure 8 5" 1”…

9, Vermont Castings VFI33LNV VFI33 Vent Free Gas Fireplace System 20307670 9 CLEARANCES HEAT RESISTANT MATERIAL (MINIMUM REQUIREMENTS) WITH NO WOODEN MANTEL OR OTHER COMBUSTIBLE PROJECTION Heat resistant material (minimum requirements) with wooden mantel or other combustible projection: To install the heater with a wooden …

20, VFI33 Vent Free Gas Fireplace System 20 20307670 RED RED RED RED RED BLACK D/C POWER GREEN GROUND BROWN BLACK BLACK ORANGE YELLOW BLACK BLACK RED CAUTION Electrical connections should only be performed by a qualifi ed, licensed electrician. Main power supply must be turned off before connecti…

27, VFI33 Vent Free Gas Fireplace System 20307670 27 LOG PLACEMENT INSTALL 18", (F,R) HIGHLAND OAK LOGS ON NAT- URAL BLAZE BURNER (AVAILABLE FOR MAJESTIC SYSTEMS ONLY) 1. Place the #1 log (the “chunk”) on the grate bar right side of the burner adjacent to the controls. Figure 33 Figure …