Western HTS Owner's Manual

90, Lit. No. 49513, Rev. 00 91 August 15, 2011 Annual Fluid Change 1. Perform this operation with the snowplow attached to the truck on a hard level surface. 2. Lower the blade to the ground. 3. Activate the control FLOAT function and manually collapse the lift ram all the way (not …

85, Lit. No. 49513, Rev. 00 86 August 15, 2011 MAINTENANCE 4. Replace the cutting edge when it is worn to the bottom of the blade. MVP PLUS™ Cutting Edge: To equalize wear, refer to the leveling adjustment procedure in the following cutting edge section. 5. Straight Blade a…

22, Lit. No. 49513, Rev. 00 23 August 15, 2011 NIGHTHAWK™ SNOWPLOW HEADLAMPS The NIGHTHAWK snowplow headlamps include a set of rectangular, dual-beam, halogen headlamps plus combination park and turn signals. A prewired harness with a plug-in module requires no headlamp wire splicing. T…

24, Lit. No. 49513, Rev. 00 25 August 15, 2011 Straight Blades Fill Plug Drain Plug Reservoir Valve Manifold Breathe r Quill Motor GETTING TO KNOW YOUR SNOWPLOW The WIDE-OUT™ blade is both raised and angled side to side in approximately 2 seconds. Each wing individually extends and retr…

65, Western HTS Lit. No. 49513, Rev. 00 66 August 15, 2011 OPERATING YOUR SNOWPLOW WARNING Keep 8' clear of the blade drop zone when it is being raised, lowered or angled. Do not stand between the vehicle and blade or directly in front of blade. If the blade hits you or drops on you, you could be…

79, Lit. No. 49513, Rev. 00 80 August 15, 2011 MAINTENANCE 4. Mark (or tape) the vertical centerline of the snowplow headlamps and the vertical centerline of the vehicle on the screen. Mark the horizontal centerline of the snowplow headlamps on the screen (distance from ground to snowplow headl…