Westfield AeroRace 2008 Build Manual

20, Revision 94 Chapter 3 Wiring Loom Contents INTRODUCTION .............................................................. 1 Tools Required ................................................................ 1 Standard Parts ................................................................ 1 Parts …

26, Wiring Loom 3•7 2.3 3 Fit two saddles to the passenger side bulkhead (Fig 2.4). 2.4 4 Fit two saddles across the top of the passenger side bulkhead and two down the right hand side of the nearside bulkhead (Fig 2.5). 2.5 3 Positioning -Rear …

4, Safety II Safety You will not need to use welding or grinding equipment in the building of a Westfield sports car. However, it is very important that you take ALL necessary SAFEY precautions. 1. ALWAYS WEAR Goggles or protective glasses when drilling. Protective glov…

97, 1•3 SVA Cover Set FITTING OF SVA COVER SET 1 Front Bolt Covers 1 Locate from your parts (six M6 Hex Head Bolt Covers[C]) 2 Position the four M6 covers [C] on the anti roll bar clevises nuts and bolts, if your car is running anti roll bars. The covers a…

51, Fuel Tank & Supply System 7•5 4.1 4 Secure the pump with two M5 nyloc nuts. 5 Fitting – Fuel Hose NOTE: Use the fuel system layout on page 7.4 to familiarize yourself with the layout of the hoses. Fit all the fuel tube before the tank is f…

11, Westfield AeroRace 2008 Aluminium Paneling 1•4 3 Panelling - Inner Footwell 1 Fit the inner footwell panels [G,H], repeating the process used for the tunnel panels. NOTE: Unlike the other tunnel panels, the inside footwell panels are fitted to the inside of the tunnel. This p…