Vision Fitness U70 Service Manual

34, 30 7.8 SIDE COVER REMOVAL 1) Use a flat screwdriver to turn the cover over the crank arm counter-clockwise and remove it (Figures A & B). 2) Remove the 14mm nut holding the crank to the drive axle (Figures C & D). FIGURE A CHAPTER 7: PART REPLACEMENT GUIDE FIGURE B FIGURE C FIG…

29, 25 7.3 HEART RATE HANDLEBAR REPLACEMENT FIGURE A CHAPTER 7: PART REPLACEMENT GUIDE 1) Remove the 2 bolts on each side holding the heart rate handlebars to the console mast (Figure A). 2) Remove the heart rate handlebars. 3) Reverse Steps 1-2 to install a new heart rate handlebar.…

28, 24 7.2 CONSOLE REPLACEMENT 1) Remove the console back as outlined in Section 7.1. 2) Remove the 4 screws holding the console to the console mast (Figure A). 3) Disconnect the 3 wire connections (5 if a TV is present) to the console and remove it (Figure B). 4) Reverse St…

24, 20 6.4 TROUBLESHOOTING - NO RPM DISPLAYED CHAPTER 6: TROUBLESHOOTING NO RPM IS DISPLAYED DURING EXERCISE POSSIBLE CAUSES: 1) The generator is damaged or the console cable is not connected properly. 2) The console is damaged. 3) The lower board is damaged. SOLUTION: 1) Open the …

6, 2 CHAPTER 2: IMPORTANT SAFETY INSTRUCTIONS 2.1 BEFORE GETTING STARTED The Vision Fitness U70 Bike is intended for commercial use. To ensure your safety and protect the equipment, read all instructions before operating the bike. CHOOSING A SITE The site should be well lit and well v…

13, Vision Fitness U70 9 CARDIO PORT A cardio port is located on the back of the console that is compatible to entertainment protocol such as Cardio Theater. The bottom port is the active port to use for this function. CHAPTER 4: CONSOLE OVERLAY AND WORKOUT DESCRIPTION 4.1 CONSOLE DESCRIPTION - CONTINUED …