Vision Fitness R70-02 Service Manual

17, 17 CHAPTER 4: TROUBLESHOOTING 4.6 Troubleshooting – Pedals Slipping PEDALS SLIPPING POSSIBLE CAUSES: 1) The belt tension is not high enough. 2) The one way bearing is damaged. SOLUTION: 1) Remove the covers and check the belt tension. a. Tighten the drive b…

11, Vision Fitness R70-02 11 CHAPTER 3: ENGINEERING MODE 3.1 Using Engineering Mode – Continued CUSTOM SETTING DEFAULT MINIMUM MAXIMUM DESCRIPTION MAX TIME 99 min 5 min 99 min Set a maximum workout time USER TIME 60 min 5 min 99 min Set a default workout time DF AGE 40 10 100 Set a default age for al…

41, 41 CHAPTER 5: PART REPLACEMENT GUIDE 5.20 Generator Replacement 1) Remove the shrouds as outlined in Section 5.16. 2) Remove the cable ties on the wire connector of the generator and unplug the generator wire from the LCB (Figure A). 3) Remove the nuts holding the generator to the fram…

22, 22 CHAPTER 5: PART REPLACEMENT GUIDE 5.3 Console Mast Replacement 1) Remove the console as outlined in Section 5.1. 2) Remove the HR handlebars as outlined in Section 5.2. 3) Lift up the rubber boot at the bottom of the console mast (Figure A), and remove the 5 screws holdin…

33, 33 CHAPTER 5: PART REPLACEMENT GUIDE 5.13 Lower Control Board Replacement 1) Remove the rear shrouds as outlined in Section 5.12. 2) Disconnect the 3 wire connections to the lower board (Figure A). 3) Remove the 2 screws holding the lower board to the frame (Figure B), and remove the low…

43, 43 CHAPTER 5: PART REPLACEMENT GUIDE 5.21 Drive Axle Set Replacement 1) Remove the front shrouds as outlined in Section 5.16. 2) Remove the drive belt from the pulley by hand (Figure A). 3) Remove the C-clip holding the bearing in place on the left side of the frame (Figures B & C).…