Vivitek D-Point 2 Operation & User’s Manual

9, Vivitek D-Point 2 - 7 - When Installation is finished,  D-Point 2 icon will be created on the desktop.  Installation folder will be created on C: directory. Upon starting D-Point 2, the configuration window will appear on the desktop to assist in setting …

20, - 18 - 7.3.2 Mounting Method of DT01 Multi-touch Interactive Module 2 kinds of method : Install the adhesive tape on the rear side of the DT01 Multi-touch Interactive Module. Following the instructions above to position the DT01 on the screen. Note: (thickness: 1mm) is recommended. …

21, - 19 - 7.3.3 Connecting DT01 Connecting DT01 Use the USB cable to connect the DT01 for power supply. There are three ways to connect the DT01. Connect DT01 to Projector (Recommended) Note: USB type-A power is available for selected projector model. Connect DT01 to Compu…

7, - 5 - 4 Driver Installation System Requirements Operating system - Windows XP, Vista, Windows 7, Windows 8 Hardware PC requirements REQUIREMENT CPU higher than Pentium RAM higher than 512MB Hard Disk higher than 100MB USB USB 2.0 CD-ROM higher than…

23, - 21 - 7.4.3 Laser Curtain Alignment Principle Rolling/Pitch/Level control of Laser Curtain Knob 1 : Pitching control / Knob2, Knob3 : Rolling control Pitching control Rotate knob 1 in clock wise, then laser curtain goes up like figure below. And if rotate knob 1…

2, - i - Contents 1 Accessories of D-Point 2 ................................................................................................. 2 2 Connecting Projector to PC ............................................................................................ 4 3 Pen Action .............…