X-Factor X–60 Assembly Instructions Manual

14, X – 60 Instructions Version 1.0 Page 14 A5) Gather the idler gear (9360) from your T4, the idler gear from Bag A, the two 3/8 X 3/16 bearings (6906) from your T4 and the two 3/8/ X 3/16 bearings from Bag A (left photo) Install two bearings in each idler gear, one from each side. (…

8, X – 60 Instructions Version 1.0 Page 8 12) Remove the inner camber link ball cups from their studs. Leave them attached to the turnbuckle and leave the other end of the link attached to its ball stud at the hub carrier. Then remove the ball studs. Save the ball studs and any…

2, X-Factor X–60 X – 60 Instructions Version 1.0 Page 2 TABLE OF CONTENTS T4 Disassembly………………………………………………………….... 5 Bag A – Transmission Assembly………………..………………………. 12 Front End Installation…………

16, X – 60 Instructions Version 1.0 Page 16 A10) Install the 4-40 X 3/8” bolt in the corner (short arrow) and the 4-40 X ½” bolt (from instruction #22) in the rear center of the transmission (long arrow). Leave them finger tight until step A12. Make sure the head …

7, X – 60 Instructions Version 1.0 Page 7 REAR CVDs & HUB CARRIERS 8) Remove the wheels and tires. Save them and the nuts for re-use. 9) Remove the two nuts that hold the top of the rear shocks on. Save them for re- use. Slide the shocks off t…

12, X – 60 Instructions Version 1.0 Page 12 BAG A TRANSMISSION ASSEMBLY Let’s do this first because the parts are right in front of us. CLEAN IT UP! A1) We suggest you clean and inspect all your T4 transmission parts at this time. You might wan…