Wincor Nixdorf BA90 Operation & User’s Manual

15, Wincor Nixdorf BA90 BA90 User Manual 9 Preparing the display 1. Place a piece of protection sheet on a flat surface e.g. a table. 2. Lay the display face down on the protection sheet. 3. Tighten the two screws half way through. 4. Remove the cable cover at the bottom of the display. …

4, All brand and product names mentioned in this document are trademarks of their respective owners. Copyright © Wincor Nixdorf International GmbH, 2013 The reproduction, transmission or use of this document or its contents is not permitted without express authority. Offend…

18, 12 BA90 User Manual Connector panel (BA90 pc-Touch) The following sockets are located under the bezel of the display: Power Jack Current supply for the screen via external power supply (12V) USB-B USB connection to the PC system DVI-I / PLINK2™ DVI-I / PLINK2…

21, BA90 User Manual 15 2. Move the DVI cable, power cable and USB cable through the holder and plug the connector into the jack. Fix the connector by rotating clockwise the knurled screws. Lay the necessary cables in- side for example USB A ca- ble and connect the plug.…

7, BA90 User Manual 1 Introduction From Point-of-Sale To Point-of-Service With the BA90 you are using an ergonomically and customer-friendly cash- ier's workplace. Equipped with a sleek modern bezel free design and robust aluminum housing, the BA90 features projected capacitive…

13, BA90 User Manual 7 Cleaning Instructions Always turn off the system before cleaning The glass surface of your Touch Screen should be cleaned with a mild, abrasive free, commercially available glass cleaning product. All pH neutral materials (pH 6 to 8) are good for cleaning. Cl…