Xyron Pro 1255 Operation & User’s Manual

1, The XM1255 is an economical and easy to use document finishing system. This versatile and non-electric system has been designed to laminate or apply mounting adhesive to a variety of media. The same system is capable of laminating, selectively applying adhesive or laminating and applying …

2, Xyron Pro 1255 Features & Functions Input Tray Used to guide items into the machine. Leading edge of document should slide underneath paddle for best results. Tray has extendable "arm" for use when loading long items. Arm is shown closed. Top Cover Opens up for car- tridge replacement (s…

3, Remove the XM1255 and crank handle from the packaging. Install the crank handle by carefully threading it clockwise into the threaded opening in the side plate until tight. When tightening the handle, hold the rubber rollers inside the machine, to tighten as snug as possible. Set…

4, Basic Operation Trim to desired length using the cut blade at the roller exit. Apply downward pressure on the orange blade holder and slide to the left or right. TIP To save a later trimming operation, turn the crank to advanced the document until the leading edge is aligned with the upper …

5, Available Supply Roll Adhesive Application Roll Set Lamination Cartridges Combination One Side Laminate / One Side Adhesive Application Cutter Permanent High-Tack Adhesive: Extremely aggressive adhesive instantly creates a permanent bond on most surfaces. Sets instantly and will not pe…

6, Cut blade does not cut Adhesive build-up on Use caution and follow cleaning smoothly. cutting mechanism. procedure listed below. Film does not exit Material is curled or Remove material and clean dispenser between upper adhesive has been trans- adhesive from rollers if necessary. and lo…