Winland EnviroAlert EA200 Installation & Owner's Manual

21, D-011-0093 19 Selecting Mounting Location for EA200 / EA400 Select a mounting location for the EA200 / EA400 considering the following:  Install the EA200 / EA400 where authorized personnel can readily access the device. If required, consideration should be made regarding a location…

14, 12 D-011-0093 8 Limit display. Shows the programmed HIGH limit and LOW limit points where measured con- ditions exceeding limits will trigger an alarm for the related Zone. • When programmed for temperature, the limit range allowed is between 299 degree units to –58 degree units. • When prog…

13, Winland EnviroAlert EA200 D-011-0093 11 Display Icons Index No. Icon Function 1 Date icon. Indicates EA200 / EA400 Date Set mode is accessed. 2 Time Set display. Indicates Time Set mode is accessed. 3 Time/Date/Year display. During setup, multiple function display for setting year (4-digit), date (month.da…

43, D-011-0093 41 An alarm indication for any mode is shown by:  Flashing data corresponding to the Zone where the alarm is occurring.  An (Alarm) icon will flash during an alarm, and is solid if time delay is activated. When time delay expires, icon will flash indicating an output re…

25, D-011-0093 23 EA200 / EA400 Connectors Connector Function PWR IN Provides power connection for unit. Be sure to observe proper voltage requirements for both 12V and 24V models. CAUTION: Observe (+) and (-) polarity markings screened on circuit board. EA200 / EA400 can be damaged if power po…

50, 48 D-011-0093 Low and High Adjust Range: • Temperature: • Humidity: • Water Presence: –50°C to 150 °C –58° F to 299° F 5 to 95% RH No Alarm / Alarm Note: Usable range is also determined and may be limited by the sensor used. See “Accessories” on page 44. Zones • (1) Tempe…