Wisper 906 Alpino Owner's Manual

15, direction to provide more clearance, and anti-clockwise for less clearance. 14.3.2. Removing and installing pads. Caution: The pads and rotor must be kept clean and free from oil or grease based contamination. If the pads become contaminated you must discard them and replace them with a new se…

18, the saddle post are visible above the quick release collar 18 Rims and spokes 18.1 It is essential to have your spokes checked and tightened after 300 miles. This is a free service provided by your supplier. If this service has not been undertaken at the correct time this may cause damage to…

9, Battery specifications Cell Type Advanced Environmental Lithium Polymer with PCM Capacity 8Ah or 14Ah Rated voltage 37V Main Controller specifications Low voltage safeguard 31.5V Overload current safeguard 15A Main hub motor specifications Motor type Hi speed bru…

20, or Wisper Ltd 10 Oakenbrow Sway Hants SO41 6DY Tele:01590 681553 Mobile:07977 185830 [email protected] www.wisperbikes.com Copyright January 2010 Wisper Ltd - 20 - …

16, Wisper 906 Alpino 14.3.3.3. Use a 3mm Allen wrench(Refer to picture) to adjust the left side caliper’s pad 0.3mm clearance between the rotor. 14.3.4. Removing and installing pads. 14.3.4.1. Unscrew two caliper screws fixed in the rear fork. Remove the clip(Refer 14.3.3.1 picture), and then unscew the bolt sho…