Woosh Big Bear Operation & User’s Manual

7, 7 Seat-post/saddle: The seat-post simply slides into position and then the clamp is used to secure it. To adjust the height of the saddle, simply open the clamp and position the seat-post at the desired height and then close the clamp to lock it into position. It may be necessary to tighten th…

9, 9 On the rear of the battery is a meter which gives you a rough idea of the remaining battery capacity. To activate this meter, simply press the button in the middle as shown below. The more lights that come on, the greater the remaining capacity. For a more accurate idea of the battery …

15, Woosh Big Bear 15 Riding Distance/Total Distance To change the display between riding distance and total distance, press the Mode button. The current mode is indicated by “Trip” for “Current Trip Distance” and by “Odo” for “Total Distance”. Control Module Battery The “co…

13, 13 To attach the light to the handlebars, undo the thumbscrew and slide the fitting over the handlebars, then re-tighten the thumbscrew to secure the fitting in place. Once in place you can slide the light/torch into po- sition a shown. It may be necessary to adjust the thumbscrew on th…

11, 11 Riding the bike cont. Your bike features 7 speed Shimano index shifting gears which are changed using the thumb selector on the right side of the handlebars. When the thumb stick is fully extended, the bike is in first gear (the easi- est to pedal). To move up through the ge…

8, 8 Charging/locking the battery: When the bike is shipped, the battery is secured with cable-ties instead of being locked with the key. This is done to avoid damage to the battery locking mechanism in transit. Some delivery drivers take more care than others, so by securing the battery in thi…