Zartek ZA-725 Operation & User’s Manual

5, ZA-725 User Manual 04 ZA-725 User Manual 03 BATTERY INFORMATION Initial Use New batteries are not charged fully in the factory. Please charge the battery for 5 hours at least before first use. This initial charge pre-conditions the battery for full capacity. Failure to charge fully may shorten t…

9, ZA-725 User Manual 12 ZA-725 User Manual 11 recharge when getting flat. If an almost full battery is recharged, the charging cycles are not optimized. 3. When the battery charge goes flat, the radio’s LED will flash a red light and the radio will keep reporting “Please charge the battery�…

11, ZA-725 User Manual 16 ZA-725 User Manual 15 PROGRAMMING (OPTIONAL) A programming cable is needed to program different channels or functions on the ZA-725. The programming cable links the radio to USB port on a PC or laptop. USB installation: USB cable driver software for your computer o…

13, ZA-725 User Manual 20 ZA-725 User Manual 19 Squelch Level Checking Either side key can be programmed to enable this function. When you press the side key to check the squelch level, the radio will indicate the level 1-9. There will be no indication if the squelch is at level 0 as it is…

12, ZA-725 User Manual 18 ZA-725 User Manual 17 PROGRAMMABLE SIDE KEYS You can program specific functions for SK1 & SK2 keys via software. Press the key to activate/deactivate the function. A single beep sound “di” will indicate that the function is active and a double beep …

14, Zartek ZA-725 ZA-725 User Manual 22 ZA-725 User Manual 21 Monitor Momentary The squelch circuit on the transceiver mutes the speaker automatically, when no signals are present. So you will not hear background noise. Press the Monitor key to deactivate the squelch manually. This is useful whe…