ZonarSound MP600x600 Installation Manual

7, Page 7 The ZonarSound System Installation Manual Issue 01 4.2 Fitting the Speaker Panels Ensure that all health and safety procedures are followed during the installation of the • ZonarSound speaker panel. Remove the existing ceiling tile.• Replace it with the ZonarSound speaker …

16, ZonarSound MP600x600 DCLA 100 Amplifier Dimensions (mm) 190 x 150 x 52 Audio input connection RCA-Phono Stereo Panel volume control 0dB to Max SPL Input gain selection +6dB Internal jumper selection (Unbalanced only) Audio IN 1V RMS Recommended level Supply voltage 24V dc (absolute minimum = 22V dc) L…

3, 2. 1. Warning! High voltages are present inside the speaker panels and DCLA100 Amplifier. 2. The ZonarSound system components must only be used with a Class II Power Supply. 3. Always disconnect the ZonarSound components from the power source before making or removing any conne…

8, Buffered LL Audio Output Slave Speaker Outputs Gain Adjust Header Internal Speaker Connection +1 +2 +3 Gain Adjust Header Amplifier gain setting (for unbalanced audio): Header fitted in LO position: 0dB. Page 8 Each of the connection options are described below: 24 Vdc Out to Next Master P…

14, Page 14 The ZonarSound System Installation Manual Issue 01 5.2 Setting the Sound Level Power Audio Output Fault Volume Once the audio source has been connected and the DCLA 100 has been powered, the volume control located on the front of the DCLA 100 sets the volume for all Slave panels. To ensure…