Shimadzu LC-10 Operation & User’s Manual

22, Shimadzu LC-10/20 System 4 Using the control module 4 Using the control module Several new tabs appear in the Method Setup dialog, based on the settings performed in the Shimadzu LC-10/20 System Setup dialog. These new tabs enable the setting of the Shimadzu system operation progra…

25, 4 Using the control module Clarity Controls 4.1.2 Method Setup - LC Gradient The Method Setup - LC Gradient dialog serves for setting up the LC instrument method. Fig 10: Method Setup - LC Gradient Gradient Table A table for setting the composition of the mobile phase and the overall…

46, Shimadzu LC-10/20 System 4 Using the control module 4.2.4 Method Setup - Acquisition - Analog Output Fig 27: Method Setup - Acquisition - Analog Output Auxiliary Range Sets output range of integrator terminals. Caution: Auxiliary range will affect the acquired signal. For RID-10A and RID-2…

20, 3 Installation Procedure Clarity Controls 3.4.2 Shimadzu LC-10/20 System Setup - Controller Fig 8: Shimadzu LC-10/20 System Setup - Controller Switches System Protect While checked, in case of exceeding the maximal pressure the flow rate will be decreased to one half of the set v…

31, Shimadzu LC-10 4 Using the control module Clarity Controls LC Valve tab Tab listing the Valve Position table. Each row defines the change of the valve position in given time. These settings can be later printed as a part of the report. Note: The valves set on particular pumps may not be governed from the Method …

47, 4 Using the control module Clarity Controls 4.2.5 Device Monitor The Device Monitor window can be invoked by the Monitor - Device Monitor command from the Instrument window or using the Device Monitor icon. It displays the actual wavelength and the lamp used, the cell temperature (if configur…